70MAI KIT CAMERA PARKING MODE POWER SUPPLY 70mai HARDWIRE KIT UP02 POWER ADAPTER CONTENTS OF THE SET Hardwire Kit UP02 Adapter User manual in Polish TECHNICAL DATA POWER ADAPTER UP02 Cables for connection: ACC, VCC, GND- Input voltage: DC 12-30 V Output voltage: 5 V Output current: 2,4 A Cable length: 3 m Round-the-clock parking mode in 70mai cameras The 70mai UP02 Hardwire Kit Midrive is a power adapter that will help you connect your car cameras to your car's electrical system. The video recorder will then be powered by the vehicle battery, also during standstill. This will allow you to monitor the surroundings of the car around the clock, even when the car will stand for many hours in the parking lot. Powering the car camera in a new version The 70mai UP02 Hardwire Kit Midrive adapter converts 12-24V to 5V, which protects the car battery from discharge, which could prevent the engine from starting. The device has three input wires: Battery (red wire) connect to the DC power supply circuit, which provides voltage even after switching off the ignition. The yellow ACC cable connects to the circuit, which is active after turning on the ignition and turning the key in the ignition. The third, black GDN cable attaches to the car body element. The length of the adapter wires is about half a meter. Compatibility The Hardwire Kit UP02 power adapter is required to use parking mode for cameras: A800 4K Dash Cam, A500 Dash Cam Pro Plus, Rearview Dash Cam Wide D07. For other cameras, the adapter allows you to use the energy of the car battery. For Dash Cam Pro D02, Mini Dash Cam D05 and Dash Cam Lite D08 cameras, the adapter performs an assistive function, which means that when the device's battery is low, the Hardwire Kit UP02 will use the car battery to be able to record in parking mode. However, in the case of the Smart Dash Cam 1S D06 can only be used to maintain date and time settings.