1、Wind Turbine Controller: Wind turbine generator controller regulator can be used for maximum 600w wind turbine. It helps to control wind generator charge battery automatically. 2、Protective: When the battery is fully charged, brake can be taken effect automatically by the interior circuit. When the battery voltage drops to restore voltage level, wind turbine can recover to charge battery automatically. So wind controller to protect the wind turbine and the battery. 3、Water Resistant: The water resistant rating get IP67. Charge controller can work steadily even in very humid environment. Also including automatic over voltage braking, battery reverse connection and open circuit guard. 4、Good Heat Dissipation: Wind generator charge controller use aluminum shell with good heat dissipation. The rectification and brake circuit part has adopted integrated module design, whatever heat dissipation or reliability, all further advanced than the traditional design. 5、Automaticity: This wind turbine controller can auto match 12V 24V system. Voltage and current limiting are be controlled during recharging to ensure the best charging effect. Meanwhile, it provides the maximum guard to the wind turbine and battery. Item Type: Wind Turbine Charge Controller Material: Aluminum Case Weight: Approx. 476.00g / 16.79oz Size: Approx. 15x8.5x3cm / 5.91x3.35x1.18in Charging Method: MPPT Rated Battery Voltage: 12V 24V Rated Wind Turbine Capacity: 300W 600W (Peak) Level: IP67 Display Mode: LED (Light Emitting Diode Display) 1 x Wind Turbine Controller