Item Type: Dual Power Automatic Transfer Switch_x000D_ Material: ABS, aluminum alloy_x000D_ Rated Current: 125A_x000D_ Handle Color: Red_x000D_ Rated Voltage: 400V AC_x000D_ Frequency: 50Hz_x000D_ Pole Speed: 2P_x000D_ Rated Impulse Withstand Voltage: 4 (KV)_x000D_ Insulation Voltage: 4000 (V)_x000D_ Working Principle: _x000D_ This series of dual power supply controller and drive mechanism power supply signal depends on the A phase and N line of the common switch or standby switch inlet port. Dual power supply in the automatic state, when the incoming phase A and N common switch voltage is normal (AC190-240V), regardless of whether the common power supply B.C and standby switch a.b.c, N voltage is normal or not, the common switch will be closed in priority. At the same time, the power supply indicator and the common off indicator light up. When the incoming public switch A phase and line N have no voltage, and the incoming standby switch A phase and line N have normal voltage, regardless of whether the normal switch B and standby switch C have normal voltage, the dual power supply turns to standby closure. The power indicator and standby closure indicator are on. Manual function, regardless of whether the voltage of normal power supply and standby power supply is available or not, manual operation mode can be used. For manual operation, the manual automatic button should be placed in the manual operation position. Push the handle to rotate clockwise to the terminal, the standby power vac open R open, common power vac open N close. When pushing the handle to rotate counterclockwise to the terminal, the standby power switch R closes and the public power switch