Features: 1.The pulse relay can be configured to activate the detection of the vehicle or when the vehicle leaves the loop. 2.This characteristic determines the non-detection level at maximum sensitivity to avoid detecting vehicles such as large trucks. 3.Sensitivity can be changed using four sensitivity settings on the switch. 4.Four frequency configurations can be used to avoid signals from interfering with adjacent loops. 5.This relay is typically used to prevent false detection of small or fast objects. Specification: When the detector is tuning, the green channel LED and the red power LED will illuminate. It stays for about 2 seconds and then the green LED goes out. If there is a loop failure, the channel LED will illuminate and flash to indicate a fault. If the fault is self-healing, the detector will continue to run. The green channel LED will also illuminate as soon as the vehicle is detected to pass through the inductive loop. The red power LED on the top of the unit will remain lit, indicating that the unit is powered._x000D_ _x000D_ Features:_x000D_ _x000D_ The pulse relay can be configured to activate the detection of the vehicle or when the vehicle leaves the loop. _x000D_ This characteristic determines the non-detection level at maximum sensitivity to avoid detecting vehicles such as large trucks. _x000D_ Sensitivity can be changed using four sensitivity settings on the switch. _x000D_ Four frequency configurations can be used to avoid signals from interfering with adjacent loops. _x000D_ This relay is typically used to prevent false detection of small or fast objects. _x000D_ _x000D_ Specifications:_x000D_ Condition: Brand New_x000D_ Material: ABS_x000D_ Color: Black_x000D_ Reaction time: 10 ms_x000D_ Supply voltage: 220 V_x000D_ Power consumption: 4.5 VA_x000D_ Output relay: 240 V/ 5 A_x000D_ Voltage tolerance DC: 15%_x000D_ Withstand voltage AC: + 10%/ -15%_x000D_ Operating temperature: -20C to +65C_x000D_ Storage temperature: -40C to +85C_x000D_ Frequency range: 20 kHz to 170 kHz_x000D_ Sensitivity: adjustable in 4 increments_x000D_ Signal hold time: unlimited /limit cycle for 10 minutes permanently_x000D_ Loop inductance: The total loop plus connection line is 50H to 1000H (ideally 100H to 300H)._x000D_ Loop connection wiring: Maximum length 20 meters, twisted at least 20 times per meter._x000D_ _x000D_ Package List:_x000D_ 1* Barrier Opener_x000D_ 1* Connection Terminal_x000D_ 1* Instruction Manual_x000D_ _x000D_ Note:_x000D_ 1.The detector must be installed in a convenient weatherproof position as close as possible to the loop._x000D_ 2.The installation location must be chosen away from the heat source._x000D_ 3.Other equipment around it must be at least 10 mm away (not to be tightly mounted to the wall)._x000D_ 4.Proper loop configuration and detector installation will ensure a successful inductive loop detection system._x000D_ 5.Several important parameters of the loop include: cycle diagram, size, turn, and installation method._x000D_ _x000D_ 6. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.