1Function: After installing emulator, you can remove DPF sensors NOx sensor, (only in DAF, don't remove first NOx sensor), For Adblue Temp, sensor, For Adblue Pump, etc. 2Disable for AdxBlue System: It is possible to disable for AdxBlue system by installing an for AdxBlue emulator (programmable device) into the vehicle. You can switch it on or off anytime. 3Simple to Use: Emulator does not need to be learned. You install emulator under the metal cover of for AdBlue pump on the right side behind the cab, and disconnect plug from. 4Premium Material: Truck scanner emulator is made of premium ABS plastic, which is impact resistant, high temperature resistant, not easy to crack or break. 5Small and Portable: Professional manufacturing, high performance, strong reliability, and it is small and lightweight, easy to carry, bringing you more convenience. Item Type:Emulator Material: ABS Emulators Disable System: For AdxBlue system (Fully) For AdxBlue NOX sensor DPF system DPF temperature sensors DPF regeneration After installing Emulator, you can remove: DPF sensors YES NOx sensor YES (only in DAF, dont remove first NOx sensor) For Adblue Temp, sensor (s) YES For Adblue Pump YES For Adblue Level sensor YES For Adblue ECU YES Kindly note: It is possible to disable for AdxBlue system by installing an for AdxBlue emulator (programmable device) into the vehicle. You can switch it on or off anytime. Emulators using guide: Emulator for Man Euro 6 does not need to be learned. You install emulator under the metal cover of forAdBlue Pump on the right side behind the cab, and disconnect plug from forAdBlue Pump and connect emulator. Next, you need to remove the fuses: F894(Multisensor In forAdBlue tank) F738 (+30 Signal of forAdBlue pump) F1084 (NOx sensor Upstream) Fuse F737 is now fuse of emulator. Fuse F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature sensor. This sensor needs to work correctly for DPF regeneration. Finally you need to remove Power from NOx downstream sensor. There are two ways options, one is to cut pin 1 in NOx sensor plug, the other way (better) is to remove pin 10 in X3212 plug. This plug is visible on rear of engine on the right side. This is TE plug (16 pin) with yellow key. 1 x Emulator