The package includes 100 * floor kit for tile leveling system Features: 1. Resistant to wear, recyclable, reusable. 2. Easy to use in DIY operation. 3. Balance the tiles in the same horizontal position. 4. Improve the speed of installation of the tiles. 5. Reduce the fatigue / pressure from the installer. 6. There is virtually no flat surface and without cracks. 7. This reduces the need for sharpening and polishing. 8. Avoid that the shingles move during solidification. Features 1. Last name: Tile Leveling System Floor Kit 2. Model: D91955 3. Equipment: PP high quality + stainless steel 4. Color: Black + Orange 5. Applicable brick difference: 2-6 mm / 0.08-0.24 " 6. Applicable tile thickness: 3-16 mm / 0.12-0.63 " Place the first tile leaving more than 2 mm (with crossed joints). Near the tile. Insert the t pins next to the space between the tiles. Next, turn 180 degrees and the needle t is attached to the bottom of the Two tiles. Adjust the cover by hand / special key until the two tiles are at the same level. After leveled for about 5 to 6 hours, before That the cement / adhesive is completely dry, rotate the lid in the opposite direction and remove the t T to 180-degree needle until the ground is removed. Avoid removing the leveling tile system in T 1. The seals of the ceramic tiles measure 2 mm or more (the crossed seals are recommended) 2. When leveling, adhesive cement or tiled cement around the T type leveler must be cleaned. 3. Remove the T-type straightener about 5 to 6 hours after leveling before the tile or cement binder is completely dry. Note 1 . Due to the difference between the monitor and the light effect, the actual color of the article can be slightly different from the color indicated on the images. I thank you! 2. Please allow a slight measurement gap due to manual measurement.